The ABS light comes on in the dashboard of Mitsubishi Triton when one or more of the wheel speed sensors have malfunctioned, brake fluid is too low, the fuse is blown or the relay is bad, tire pressure is low, or if the ABS module has developed a defect. When the ABS light / comes on in your Triton, the anti-lock braking system is disabled. I posted on here a while ago with a fault on my 2005 di-d LWB shogun warrior automatic. The fault was when driving the indicators would suddenly stop working along with my Dipped beam, intermittent windscreen wipers, numberplate light, washer jets and light warning buzzer. Also the 4wd dash board indicator would go out. 2001 mitsubishi montero sport 4wd battery and brake lights are on. I doubt it is the belt because if the belt is slipping you should hear it. The alternator could be about to crash and not charging at lower speeds. You would check alternator output to find out. The battery and brake warning lights are on the same circuit. 1 Hour 1 Day 1 Week 1 Month Forever Login with username, password and session length. 156060 Posts in 18387 Topics by 12206 Members www.L200.org.uk. Owners Club card £2. Shop at Amazon.co.uk through this link. L200 Owners Club The Forum Public/Initial Posting Area. No green 4WD light!!! In some countries it is known under the name Mitsubishi Triton or Dodge Ram 50. In our material you will find a description of the 4th generation Mitsubishi l200 fuses and relays with box diagrams and their locations. Highlight the cigarette lighter fuse. Re: Interior light not working. « Reply #8 on: 15 February, 2016, 18:45:20 PM » The box you refer to is the ETACS ECU which controls most of the circuits on the car on the accessory side, if it was faulty it would affect many other items in the truck. there are no relays on the interior or door lights circuit. This indicator is typically only used for performance Mitsubishi Triton (L200) models that expect the driver to push them hard. The cause behind this could be heavy acceleration or in worst cases a loss of oil. As it is a red light you must pull over and allow the engine to cool down. What the flashing light means is that the front diff has locked in the drive shafts for the front wheels, you are not in 4wd as the transfer is still in 2wd, but the front wheels are now turning the front diff and the propshaft. Apart from a little extra wear on the diff gears you won't be doing any damage but you are likely to be using more fuel. ygHYJB.

mitsubishi l200 4wd light not working